About Us
  1. Home
  2. /
  3. About

A Brief Introduction of ZOZEN

Zhongzheng Boiler Company, its predecessor Zhongzheng Boiler Group found in 1988. Over 30 years, our company continually focuses on industrial steam boilers’ development and manufacturing. Our mission is to product A-level industrial steam boilers for each consumers. Perfect safety, high quality, advanced technology, good performance, better efficiency, less pollution... ZOZEN engineers and workers keep those points in mind during our industrial steam boilers manufacturing process. As a experience industrial steam boiler manufacturer in China, ZOZEN makes sure to provide you the best industrial steam boiler in the world.


Why choose us?

ZOZEN has built six fully automatic lines for the production of convection pipe, coil pipe, threaded pipe, membrane wall, serpentine tube and header. The parts so produced have consistent dimensions that enable easy assembly and ten years’ extension of a boiler’s life.1. Convection pipe production line: high precision of ±0.5MM. 2. Coil pipe production line: three pieces of pipes can be coiled at the same time. 114mm diameter pipes are coiled into 4.5 meters coil. 3. Threaded smoke pipe production line: tread depth is accurately measured by infrared radiation to ensure tread depth is proper. 4. Membrane wall production line: MPM automatic welding machine with 12 heads, 1600MM panel bending machine. 5. Serpentine tube production line: 150 meters pipe can be made into economizer or super heater in one time without manual seam. 6. Header production line: by medium frequency electric heating, mechanical flow forming closing and NC drilling.

Seven hold points are set and each one is supervised by a responsible inspector. Any work that fails to pass the inspection cannot proceed until the inspector is able to verify its quality. 1. Incoming materials are inspected again upon entry into the plant. 2. Material markings will be transferred to all cut pieces to ensure identification and traceability. 3. Test pieces are used to ensure a higher success rate in welding. 4. Welded joints are subjected to heat treatment in accordance with operational procedures to relieve stress. 5. Pre-expansion is performed before the welding process begins. 6. Flaw detection is carried out before shipment. 7. Hydrostatic test examines the quality of complete boilers before delivery.


Our Partners

Through long-term arduous technology research and international communication, our product quality has been in line with international level, winning a world-wide acclaim and honor, and our products are exported to ninety countries and regions like America, Russia, Kazakhstan, Turkey, Iran, South Africa, Ethiopia, Egypt, Vietnam, Malaysia, India, Australia, Korea, Chile, etc.